Craig & Louise talk about the telescoping hitch
|
Jig welded frame is .090 square tube 2". The tongue is heavier.
|
|
This is a 3500 lb rated axle with electric brakes.
|
Tongue at full extension. The idea is that the tongue can easily be taken off when stored, or fully extended for additional leverage if I need to disconnect it from the Jeep & turn it around by hand in a tight spot.
|
Galley Kitchen cabinets. Note Sliding workspace at right side. Sliders are rated for 100#.
|
The woodgrain on the cabinet doors is matched up
|
See the shelf?!
|
Sides all cut out. That's 1" thick plywood, so go ahead & lean on it!
|
Gluing the floor and aluminum together.
|
The bottom of the trailer is covered with .040 aluminum.
|
This is the floor, but upside-down. We also wanted tow points at all 4 corners. I'm sure we'll use them sooner or later.
|
Added "slider bars" to help keep this thing from getting stuck on the rocks. And protect the floor.
|
|
Galley counter ready to be installed.
|
